This method can lead you to the general vicinity of a stud but it is not considered to be accurate. They do have stud finders that can penetrate the plaster walls and reliably find the studs. You can also hunt for the studs with a screw where the cabinets will be hung, then put the cabinets up and the extra holes will be hidden behind the cabinets. The wall will sound hollow between studs, with a slightly more solid sound when you hit an area backed by a stud. The base of the plaster will be a split lath and there is a 90 chance of screwing into it. Carefully listening as you rap on the wall with your knuckles may help you narrow down but not necessarily pinpoint the studs.There's a good chance you will find studs running upward along each side of the visible vent grill. HVAC ductwork and its visible vents often fill a wall cavity, with studs on either side.You can identify these boxes because they always have a small screw at the top and bottom of the box, which is used to turn the plastic wings that hold the box tight against the drywall. Retrofit or old-work boxes are mounted to the drywall in wall cavities between studs. Problem for me is that the wall I have has NO outlets. There was a thread from 2004 about this and the answer was to find an electrical outlet to see which side had the stud and the measure 3/4' to find mid stud and then to measure either 16 inches or 24 inches from there for the other studs. ![]() Remember, though that not all electrical boxes are nailed to studs. Finding studs in metal lath plaster walls. By removing the cover plate, you can often see which side of the box has been nailed to the stud. This can help you find the general location of a stud in a wall. In new construction building, electricians usually nail the electrical boxes for light switches and outlets onto the sides of studs.Once I marked a few with a pencil, it was obvious where the studs were. Dangling the magnet along a wall revealed all the nails and screws in or beneath the drywall. Remove the shade, turn on the lamp and hold the bare bulb. These special studs are not necessarily 16 inches from the center of the adjacent studs. Step 1: Grab Magnet From Fridge, Hang With Dental Floss I grabbed a plain magnet from the refrigerator, and tied a piece of dental floss to it - any fine string or thread would work. If you dont have an electronic stud finder, you can locate studs with nothing more than a table lamp. ![]() Keep in mind that the location of these studs is determined by where the window or door is located in the wall. In fact, they will usually have two doubled-up studs-the inner jack studs and the outer king studs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |